This was when slid back doing shaft seals a year and a half ago. Was just showing that there was no bearing as discussed above.
I replaced shaft seals a year and a half ago. Pulling the shafts is not easy as the coupler connection takes some time to disconnect. No yard to...
Thanks for the input guys. Hauled out on Monday and went back into the water today. Replaced the cutlass bearings and condition was not horrible...
I have no problem replacing cutlass bearings if needed. I have looked at that each of the last 3 haul outs but am not sure what my sign for...
The only time it bothers me is when I have touched up my bottom paint and applied new zincs then go to take a pic. It looks half azz so to speak...
The shafts haven't really changed but the props and rudders have 75% worn off. Truth is I don't need to have anything on the u/w metals as the...
When I bought My Cabo there was a fresh coating was on all the underwater metals. It has performed well and after 4 years I would like to apply a...
Something about this comment rubs me the wrong way. I like this forum and there are a few on here that I appreciate the knowledge they share. ie...
Very happy with Shurhold system.
In my opinion the quality is just not in line with the others.
I have owned several of the brands mentioned and will put in my 2 cents. If fishing is not a main priority that will adjust your list as some are...
Hull number should be the 9th and 10th character. Example. US-CHXJ0050L608-..... This would be hull number 50
I am not of the opinion that a NC built Cabo is inferior. But when Brunswick sent leadership to California to manage the Cabo factory they sent...
My 40 FB is considered a 2008 but went into the mold 12/06 and was completed 05/07. Hull 50 of the 40FB series. Trucked to NJ for commissioning...
Thank you. Looking forward to being able to use the boat a bit hopefully this summer as things open up.
Have not taken the boat that far North. Did a circumnavigation of Vancouver Island in summer 2018 and fished the entire West side on our way down....
DOCKMASTER- Good point on the valve to adjust incoming water temp as the cold water can cause performance issues. That was something on the...
When I bought my 40 Cabo FB 3.5 years ago it came with an Eskimo chipper that was factory installed outboard of Port engine. Given our cold...
When Cabo built the 40 FB they left California for the East Coast with no hard top. Local dealer would work with owner in designing hard top and...
