Hey, I'm still looking to salvage a stabilizer system for our 58 Bertram MY.
From 2005? Good boat to shop for. Low CG.
Real drivers don't need no stinking thrusters..:rolleyes::rolleyes::rolleyes::rolleyes: Just need a running start. Everybody else will get out of...
The first pic has a snailbote mast listing hard also. Ice ads so much weight to the top sides. Amazing this tub did not roll over. Like to know...
Rails. WOW!!
Here in south Georgia, the local Cummins shop could not figure out (in 6 months) a sinc problem in the joystic. Every now and then the pods would...
We have been on one Cranchi years ago. Just for engine service. I observed typical Italian design and quality. Above quality to the Muts I have...
Heart Break. Modern times, Family issues and Reality sometimes Sux. Probably to late for anybody to save the project. Hopefully may contribute to...
Old LBCs prefer conventional oil. In Florida, straight 30w during the summer maybe 40w if their tired. 15w40 when the weather is cold or the boat...
Just wait till you double the heads; 12V71s sound even better. ;)
O A owners here are thin. O A operators and techs are about. I have worked on just a couple thru the years. Engine service mainly. I liked them.
Are the oil pans stamped metal or cast? Stamped pans should be 5 qts. How about the dip tubes, hose adapters on the top ends or low auto version?...
Have you tried the products support?
Get a bunch of estimates on the core repair. Get a bunch of estimates for engine diagnosis and worst case repair. Seller fixes it per your...
I remember ordering an electric lift pump for one of two QSCs. After the replacement, when I went to light up the second engine, it's pump was...
I had to put my boots on while reading it.
After reading through this thread I notice that the moderator doesn't want advertising...I get it... Nor e-mail addresses. Re-read your agreement...
Per my chart, yes you can. You may prefer straight 40W in hot conditions.
You want to spend time and money on wet boats. We have tried to encourage you out of it. Good luck in your projects.
Get the old one out first. You may find the part number on it from Todd, Ronco or US Plastics. At least, you will have the EXACT dimensions and...
