NO.
Leave off the spades and come back later. That's some heavy copper and steel in there and will take a while to cool down. In the mean time, I'll...
Years ago, this question came up. Please do some searches on YF. The low / air side does take some abuse from crank case vents (Walker, Racor). It...
Time to call Carver.
Yep, Yep, Yep...
You picked up some trash or the impeller is failing (or both).
I keep forgetting my swamp raised terminology is not understood by all. Patience as I try to explain; Look at the letter D. As a diagram and...
I don't mean to dismiss checking the prop and alignment of the coupler. My comment was based on ; has a seeable vibration where the shaft meets up...
I remember shooting a car and loose trim parts with metal Imron. Candy red & flake and the owner didn't notice. Whooie. Luckily I parted from body...
Typical two spade regulator. Please looks top rite of page 3. The regulator has the two flat male spades. At their bottom is a metal tag joining...
Any cheap squeegee from wallmart will do. I like the 6 to 8" cheap ones but if you have to reach a lot, as wide as you can make it work. I hope...
Lets start from the beginning. What fuel level problems are you having? Did it ever work? What have you done so far? Did you ever short the gauge...
Your saying the second wire on the out put lug, comes back to a spade connect? Well that's messed up. If both of the male spades are tied, (you...
There is a D bent in the shaft. Before it kills the clutch rear bearing, get it looked at. Great shop at American Yacht, up the canal, just before...
For glass or curtains?
You did'nt mention a wire was loose. Then you have original VDO (euro) designed sender and gauge. Keep that in mind when ordering new senders or...
Not sure about two reds on the output lug. Does one of them NOT look factory? O K, do you still have the old Alt? One of the spade wires is still...
It's hard to see the same amount of water at speed.
'87, not that old after all. Still great ole lines.
I recall capitals are checked not running, but after you have filled the cooler and packs. start motor, gently engage forward, neutral, reverse...
