The number of ships needed is not driven by, nor decided by the Navy. It is a function of the demand signal they get from Congress. The current...
Granted, I may lose my touch a bit and not be as smooth getting into the slip or a tight spot without my thruster. However, I have no doubt I can...
Yes, spring lines can work wonders. They can also be very dangerous if a cleat lets go or a line parts. And, you have to crew that has any clue...
Basically, yes. And this assumes the cutlass bearings are all good and that you are reasonably centered in your shaft log. As I understand it,...
On an outside end slip you are also exposed to all the boats that transit in/out of the marina and have to pass by you. That adds risk, especially...
Check the easy stuff first and that can be done while in the water as others have suggested. Motor mounts and alignment for sure. Final alignment...
I suggest you start a new thread to get input on troubleshooting your vibration. Lots of good input from folks here to be had. You will want to...
Ok this made me really laugh. Your buying a fantastic boat and your most pressing need is printed stadium cups with the boat name on them. That's...
Resale really depends on age and condition. Technology has really come a long way on these units. Most newer systems are more automated and also...
It shouldn't be too difficult or expensive to get a machine shop to make you a new spacer if you can't find one. It's doubtful that was installed...
Our company has an entire aluminum shipbuilding division. Lots of boats and ships that are 100% aluminum. Some get painted, some do not. You just...
I really like my set up with a 20k and 9k . The 9k covers my needs 90+ % of the time. I only need the 20k when if using the dryer, watermaker or...
Hope it works. You should be able to use an extension or pipe and not damage the threads in there. Just come up against the threads gently then...
Either get yourself a real impact like a Dewalt 20v or similar or put something in one of those radial bolt holes that sticks out so you can block...
Although having the engine oil preheated to promote better flow and lubrication is certainly a plus, I don't see this as a main reason to...
My $.02 is that the heating pads that go on the bottom of the oil pans are inferior to elements that heat coolant. When your engine is sitting...
The thing should only weigh like 400 lbs or so.Why not just make a simple lifting jig out of some wood 4x4’s or similar? Lift it up, remove and...
My remedy was to disassemble and overhaul the gear with all new clutches and bearings. I did manage to baby through the rest of the season when it...
Have you pulled your dipstick to make sure you don’t have a failed cooler and water in the oil? This can cause the clutches to swell and create a...
Is your pump 12v or 24v? If it is 24v and you decide you need to replace I’ve got a good condition used one you can have. Just cover the shipping...
