ESSR, Your 56 is a nice looking boat. your fuel efficiency at 30 kts amazes me
I don't think they know what breached the hull. looking at the picture, there it appears to be little or no damage on the wheel, shaft, or strut...
[ATTACH]
I found this interesting pic of Waste Knot. The boat is the charter boat from Oregon Inlet that recently sunk after a suspected hull breach....
can you put varnish over the epoxy? I think so, but have never done it. I know WestSystem will yellow with UV light if not covered. I use two...
Beau, I know your Post is a lot younger than 1988 and most likely has a different interior finish. This might be helpful. below was cut and...
Well said Bert, plus you sure do keep your Berts well maintained.
no, could be loose ground wire or a pressure or temp sensor right at the threshold. and that could cause intermittent alarm and not steady alarm....
Interesting idea. I have an AC disposal on my galley sink. It is a standard household item that will chop up just about anything. Running water...
good point on the gears. Mine are 1.5:1
The trade off on the following sea handling is the stability at drift, anchor or troll. You can adjust seed and weight in a following sea. There...
I went out to the shop and opened the box.
I lost!
Gray, I own a late 80's Model 46 Post. Overall, I am extremely pleased with the performance and construction of the boat. I would agree that...
is the engine room gauge mechanical or the same electronic sender as the bridge?
w0w! I am running 24x24
Bobhorn, thanks, the watermaker just moved up a few notches on the wish list.
Any pre-filter issues with silt in water? I'm guessing not, by the responses. Freshwater is what limits my time at anchor. If I had watermaker I...
anybody effectively using a watermaker in the North East US?
I have found that the "might as wells" and incidentals can really add up fast to the final bill. "might as well" do this or that now.
