It took 12 hours just to access the few wiring bundles that we could. And, of the ones we could, you can almost reach them with one hand. Plus...
In the bilge, at the foot of the master stateroom bed, is exactly where ZF recommends putting it and would've been a logical place both for...
I don't speak Italian. And the U.S. Sanlorenzo emailed the factory with the HIN number and this is exactly what the factory told them. It's in the...
No, not at all if they were done with OEM parts and a factory trained mechanic. Should be the same as new. In fact the first 150 sets of C32's...
Alexseal seems to be softer than Awlcraft 2000 and I find it to wear easier in rub areas, but does touch up easy and does have good adhesion...
The hoses are 20 years old, they're way past their expected lifespan just from an AGE and safety perspective. The OP had a hose blow off the...
I've checked every single center bilge,with a light and thoroughly, which are a bear to get the floor panels up because it has a delicate...
LOLOLOL, autopilot compass is still there, but nobody seems to know where San Lorenzo puts them and we've searched everywhere.
The compass is bad for the ZF JMS joystick. Boat has electric steering and ZF joystick and we have searched this boat high and low and cannot...
On the way back with the current it would be good to go slow.
The 1800 HP Cat's are very solid motors. Chances are yours had aftercooler issues or weren't winterized properly or some other fluke/issue. I...
Interaction probably with the wrong primer and not prepped correctly. Zinc Chromate primer is what you want, not sure what a small zinc on the...
American Marine Products in Pompano Beach,FL also made some for the luhrs like the 2006 36' open I deal with. We ended up pulling the entire...
Everything in the run should be accessible on your boat via through the toilet opening and center bilge access.
How are you running the engines? Is there a synchronizer? or Are you pushing the throttles forward and running off what the tachometers are...
Aside from what everyone else said. Have the other engine exhaust checked thoroughly as 20 years is a long time on an exhaust system and problem...
Are you sure your generator is not drawing fuel from the port tank? It could be any number of reasons, but Port gears always run a tad higher...
It depends what you're comparing it to and where the boat is located. If you have the chance to flush the holding tank several times (and pump it...
New sewage lines are pretty stiff also. The white ones, you need to heat them with a heat gun in order to get them on the nipple. You just pull...
Bleach turns caulk yellow. Acetone, just do a quick wipe and it takes it right off.
_2.jpg&contenttype=jpeg "Click for YF Listing Service")