Can't comment on temp as the water heater hasn't been on. Water from the tanks is probably 85-90. Will have the heater on this week as going on...
Agree. I only looked at flow. Didn't look at cycling time.
Did pump change before accumulator. Noticed big improvement with pump (the old one probably has been dying for a while), didn't notice much with...
New pump installed (40-60 psi cycle). Cleaned up the PO wiring (wire nuts!!!) and mounting. It does have a much nicer flow. The PO had the...
Can see our cooktop conversion at the end of galley overhall thread.
I have been considering an upper vent/grille (or maybe connecting to existing vent hood) but waiting to monitor temps with my IR thermometer to...
I haven't refinished the plugged holes from the PO's monster trim screws yet but it is bolted in place using #8 self tapping sheet metal screws...
Was fine with non flow restrictor aerator.
Thanks. That is what I'm leaning to put in.
Our current comes on at 20 off at 40. The 60 psi pump would come on at 40 off at 60.
Copper with short lengths to the pump of reinforced clear water hose (listed rating 250 psi). Not as concerned about what I know as much as if...
The manufacturer carefully notes that adjusting the pressure (when they tell you where the adjuster is) violates the warrenty, although it appears...
Did an experiment. Hooked the boat to our dock water on the dock water inlet. Put a pressure gauge on the cockpit wash-down outlet connected to...
Want to check what pressure others fresh water system is. Ours currently has a 40 psi pump, but everyone is out of stock on the 40 psi....
Final step of the oven/range to cooktop conversion now completed with custom made (by my wife's brother) built in cutting board in front of the...
Test fit. It has 4 holes near the feet which I'll use to bolt it down from underside of the shelf. Might open up over the op a little. Will...
Lucklily the mircowave was glued in with plumbers putty. A little slow pressure with a pry bar and it stretch and came loose.
https://www.go2marine.com/hynautic-steering-cylinder-boot-k22-and-k29
LFS/Go2Marine.com SKU Description Quantity Price Each Amount 204717 Cylinder Boot, K22, HP6006 2 48.84 97.68 Got them in...
I thought about some coating on the wood beam but figured the builder must have left it that way for a reason as it and the beam in the ceiling...
