Also, don't know what electrical they do but Chesapeake Dockside Mobile Marine, Chris Sjolie, was responsive and did a good job replacing my water...
The exposed contacts on the one end are 'pins', the recessed contacts on the other are 'sockets' There should be no circuit between any 2 of the...
There are a few things you can check yourself if you have a digital resistance meter. Turn off all the 120v main breakers on the panel and remove...
I went back into the panel and the EXT RECPT breaker doesn't have an ouput wire so has never been active on our boat. Finding where the bad...
I've never had or used a circuit tracer. How far away can they detect, since all the wiring is behind panels, floors, ceilings? Can they be used...
There are no 120 volt in the cockpit or main deck. There is one 120v on the bridge, which is on a "B" circuit and works (runs Starlink). There...
Mine has the phone inlet alongside the power inlet. It used to have two shore power inlets, they were removed and the current 120/240 50A inlet...
Thanks. There was one in our engine room. Installed by a PO using romex and hooked to the ice maker circuit. I removed it LOL.
Only wires under the cockpit comings are for the 12 VDC cockpit lights, unless they don't exit the plastic tube and stay in engine room. Quartz...
Does anyone know what the 120VAC breaker labeled "Ext Outlets" goes to? I'm not aware of any external to the house 120VAC outlets except the one...
I had no problem removing our microwave and replacing, once I figure hout how it was bolted in place. I've removed the garbage disposal which...
Our 89 43 Post has two water tanks under the cockpit floor. They are connected by a PVC pipe system across the boat. The water tanks gravity...
Has anyone replaced their galley faucet? How did you do it? The lines from the faucet, rigid copper, connect behind the cabinet shelf back...
We tried one of the commercial walk-through screens but the velcro around the door frame it attaches to bubbles as it changes length as the...
Both shafts were pulled, trued, couplers re-machined (one had loosened) and new dripless seals installed as part of work between sea trial and...
Nothing similar forward, and nothing on stbd side. I'm thinking it was something to either remove the old DD or install the new CAT's or both....
Anyone with a DD powered 43 able to give a guess what this added piece of wood on the bulkhead over the port side transmission might have been...
I was surprized when I first found it as the Garmin AP sensor is nowhere near.
Original AP sensor unit on my 43 is under the guest room lower bunk toward the hull and forward of the holding tank. [ATTACH] [ATTACH]
I'll have to pull the cover and see if I can find which switch it is. I've never seen a clip in/out one before. It was hard to get the screem to...
