You kep't sending fuel into the cylinder with a hole in the Piston, it can't reach compression so the fuel doesn't burn but passes through the...
That harbor is pretty small and with pretty well closed access from the road. I'm suspecting there's more to this. But I doubt anymore will be...
LP was actually pretty prevalent in the 80s and early 90s. There were garages around that did nothing but conversions to LP. A lot of commercial...
Death is such a questionable thing.
Ralph That's what I've been preaching since this started. Big mistake by not looking at the other engine .
Remember what I said in the other thread. You need to pull the head on the other engine and have the valves properly inspected. Hell, once the...
What is the life expectancy of blue hose. I have a short hose with formed elbow on my 6-71 that J&T custom made for their conversions. Of course...
Just make sure the cabinets are not made from partical board or similar as it will absorb moisture and you what happens then
Personally I'd have a custom one from Dynema.
Don't think so, the windshield on the bridge are opposite angles.
Google translate handles it quite nicely.
That would be me. I have a 1987
Could be just me but that seems to low. And I highly doubt that they can get under that motor without raising it.
What he said!
I'm betting you have 450 hp engines. And I'm betting you dropped the valve and have a dead cylinder so you're running on 5 cylinders. Not to be a...
I would urge you to have a good look at the other head as well. I had the exact same problem a few years back. Dropped the valve while cruising...
DO NOT run that engine until you get professional on site guidance. I once dumped a little more than that in about a half hour. Kissed that engine...
As a fellow 6-71 owner you should heed J's advice. If you're experiencing what you say , you could be looking at a serious bill if you mess this up.
Are you sure the babies weren't switched at birth? Surely this can't be a new boat.
The problem is that APs are installed after build by whom ever is doing the electronics install, so ultimately itsi up to the individual tech as...
