Sold. thx, rc
Naw, Somebody screwed up. I wonder if there was actually any local news reported on this? Maybe an interview with the kid that screwed up?...
All of that interior is already covered in some epoxy. It could be very time consuming in trying to fair it in. However, it would look wonderful.
last three
Attaching pictures.
I'm in Jax now working with the stuff, down to low 40 up to mid 60s. The slow stuff is working great on some thick holes. It does take 2 days...
From the pictures, it looked like foam core. Just back a tad in one direction and a ways in another direction. Scrape out some of that foam around...
If we are looking at the same cable, It will deliver 12Vdc. It would not be used for a 24v to 12Vdc converter. Do you have 24Vdc chargers or...
I was thinking at least Polly board. On smaller Jobs, I have had great results with West epoxy and 406 Colloidal Silica Filler; Make a peanut...
Tell me where your yellow negative cables connect (from the 2x2 bank). Both directly to the same bus bar? Very close? I'm concerned with that red...
Ouch. Somebody screwed up. Reminds me of the Jacksonville Police boat; Bridge just came out of nowhere and hit us,,,.,rc
So, the suspect engine is NOT overheating? Just suddenly running a little warmer? I am confused with your last statement about a water heater....
When was the last time it ran correctly? What have you done so far? And YES, it could still be the carb, fuel, intake leak, bad wire or plug, Yada...
If your asking about base timing, are you suspecting a performance problem? Electronic upgrade; upgrade or problem... There are issues that...
If this is your first trip for night transit, I would suggest a seasoned captain and even then, warn against it. Lost containers just buoyant at...
#406 comments WOW, that's a pretty ship. Shoot the guy that tracked dirt in your cockpit. I'm surrounded by Huckins boats and this one looks...
It's looks like the raised/high spots are worn. The low spots, like under a fold or crease, is not stained. Body oil/sweat or towel with some...
Looks like something or somebody has been rubbing on it. Is this riser near a entrance or hatch way? It it leaned on to access something in the E R?
Old equipment and stuff has been getting removed for several days now. Free-board has greatly increased. I hope some hours are in store for her...
Sitting for 2 years is not good. I have witnessed valve seats take on a little tint of rust, when they get run, a hot spot appears on the valve...
