correct 32v internal regulator part number is; 10474943 no jumper required.
hold on, maybe 24, be rite back.
delco part number
the small wire if there was external. I would recommend pulling the alt and sending it to a shop. If you feel adventurous, order and replace the...
the manual says run the engine to make sure the coolers are full of fluid. shut down. within a couple of minutes check the level with dip screwed...
Ah, The original 31SI Delco. Usually two cables to it. Batt + out & ground. Simple things on this model. questions; the batt + goes directly to...
UH? Leak down on a SBC? I guess that could be done. Keeps that clock going.. Lets hope again that's a broke valve spring. If the valve...
Then My understanding is, (maybe was) Detroits, Stewart Warner, standard equipment. Next learning question (for me); fuel level gauges VDO...
Problem?? The tech replaced the plug..
VDOs ? Humm.. I thought most old Berts used SW biased equipment. You're still Detroit powered? Please keep us updated. There is always more to...
12Vdc engine gauges with a resistor reduced common DC bus drawing from a 32Vdc supply. I’m not sure this is factory or how well it works. These...
K1W1 & SeaEric have passed precious information. You are the third wise man in this post in following their guide.
I'm no where close to smart enough to offer the science and math to explain. However, thru my years, I have read, heard and experienced a narrow...
WOW And they have probably done it before, and will again. Bless them.
Wild extensions I remember a Burger with a cockpit extension. The new hull bottom was raised (shallow draft) and had only enough buoyancy to hold...
One last note; there is no standard resistor. Depending if the lamp is 12 or 24Vdc and how bright the lamp needed to be, the values can change a...
If they are original gauges, and the plus & minus are intact. Is is for the backlight and monitor lights, Like my 32Vdc Bertram, not the senders....
Sad part, when they fry, the colored bands are lost. Look for a similar resistor on an other unit. I am feared somebody installed 12Vdc equipment...
That is still an oversized carb for a SBC on regular gas. Interesting. You have a cylinder that is not firing. Supposedly it's not a plug. He...
Any updates?
