Well too good to be true coolant pressure alarm went off again. Pulled sensor connection off and checked for loose wire inside black connector...
That's not the only issue on having the heat exchangers removed and cleaned. If you don't replace the o rings in the heat exchangers as risibly...
Agree the wiring harness on the primary filter is a pain. Actually have disconnected the wiring on both of mine for that exact reason. Never...
I believe that is why Man wants the HE cleaned every couple of years so the o rings don't get over compressed and saltwater start seeping around...
As a safe guideline use $1000 per foot as long as no major issues arise.
Think I'm going to give it a try. Friend will do install for a reasonable price and compressors are around $450. The evaporator portion of...
The above Tecumsch compressor is what is currently on one of my FX-16c unit which I'm going to replace. Its R22 freon. It still works but has...
Tom, Thanks for info. Where did you buy the sensor at for $150 and what is IIRC? I actually tried to pressurize the system but was unable to...
Have not had to replace the monitoring boards although I have heard of this problem and the cost involved to replace them. Again will have to...
Today, went into the engine room to check the wires and coolant pressure sensor. Didn't find anything wrong although slightly tightened black cap...
Capt J Thanks for the info. For whatever reason we have never had to pump up the heat exchangers when replacing coolant for thermostats or...
Just removed, cleaned and replaced the heat exchangers. After replacing everything I have a coolant pressure alarm on port engine. Here's what...
Tom, Interesting how much cooler your motors run than mine. Mine run about 192 at 1900 in the summer water. Thanks for the response. Skip
Wow your owner is putting on some hours. Glad I'm not paying that fuel bill. Your correct no barnacles inside the engine or heat exchangers...
My heat exchangers were approximately 50% blocked and one engine the temp had climbed about 4 degrees so the need was there to remove and clean....
Just removed the heat exchangers to have them cleaned on my Man CR's. Pretty large job about 3 days labor. Its been 3 years. Man...
More info is requested for help. What type of toilet. Vacuflush, Electric, Hand, Saltwater or Freshwater, etc.
There isn't anything metallic close to compass. It has always been mounted in the ceiling area above the master bed on the forward wall. Could...
Been out of town and returned this weekend. Went out in the boat and problem has corrected itself. How I don't know but autopilot and rate...
