$7200.00 OBO Located in my heated garage and able to run on hose or water test as long as the water is a liquid! 2007 Rigid 10' Sport Tender...
303 is a product like armor all. I use it on my seats and vinyl all over the boat and it is the best stuff I've used. This of it like spraying...
Nothng replaces an actual wax or sealant. The 303 will be gone after the first rain and streaky everywhere. I use rejex and it really is quite...
Judging by the pics of the boat, the waterline has not been raised. Since the striping is also the Carver blue/grey they used in 1994 that also...
If you can post a picture of the boat I should be able to tell pretty easily if the waterline has been raised at all.
There is no way a 800 lb (max) tender is dragging the boat down that much. I've had way over 800 lbs of people on board my boat with gas engines...
I have an old Carver factory spec book that shows a 1994 Carver 440 with 350 HP 3116 Cats cruising at 19/20 Knots and getting 22/23 Knots at full...
Your 440 should be cruising quite a bit faster than 12 knots. Cruise speed on several that I am familiar it's is anywhere from 17-25 depending...
There is always a chance, see what the diver says and go from there. There is always a possibility that it isn't pushing enough fluid or strong...
From running a few 440s you should have a noticeable difference in movement. Somebody along the way had to add that logo on the stern, or a...
The pumps are below the aft bed. However you do not own a Carver Californian, The Cal name was dropped in 1991 and they never built a 440. The 440...
A lot of it depends on your standards. Have you ever seen the exterior finish alone on a cruise ship vs a super yacht? I think the better...
Give the dash a good bump around the ignition, ill bet it starts buzzing again.
Anything exterior that will be seen on a seam I use the UV 4000
I'm thinking those frames have screws that old them on inside the tracks. However I've never seen one leak and I believe that window is sitting on...
I have a 1994 370 Aft. One of my friends has done this on his 1995 440 though and said it was just as straightforward.
Highly doubt it is in the track itself. Mine leaked for about 2 weeks before I re-bed it. The water was coming in at the top of the frame and...
The windows on a 440 should be a very easy fix to rebed. Unscrew the frame on the outside and pull it outward. Clean, re bed, screw back in. No...
Mine are a grey color but yes, the aft windows should come out exactly the same way, unscrew from the outside and pop it off. Some of the...
Starboard side salon. All of the windows in the salon (fwd and both sides) are installed exactly the same.
