Thanks I’ll check it out
Anyone have any knowledge on this manufacturer? our 600# lift has a pneumatic shock to help hold the weight while lifting. It no longer helps....
impellers were flexible, and no cracks. Not sure of age but guessing under 10. Filters are of the same design I am using now. Only one...
I have a 13 k Koehler generator on my 2000 carver 450 voyager I found today a kit that came with the boat buried in the bilge. It has inside a...
Yes I noticed the Corrosion. I know from outside of the boat you can push and pull on the rudders and there is no play. I guess if there was...
So here are some better photos. Any suggestions?[ATTACH][ATTACH][ATTACH]
[ATTACH] [ATTACH] ok I don’t know why I had these but it accidentally shows rudders. Does this shed any light on a diy fix for small leakage...
I knew this was coming.... I just ran out of time putting the boat away and forgot to go back in and get photos. can’t get back to boat for a...
I own a 2000 Carver 450 voyager. the two rudders pass through the hull in a small recessed area. I am collecting maybe a quart of water on each...
Thank you!
[ATTACH] [ATTACH] This is the latch on the two storage wells built into the swimstep. Need to replace. What is the name of this part? Thanks...
I know I’m late to the party on this thread but have related question. I have twin aluminum tanks in my 2000 450 voyager. No leaks a little...
My oldest grandson is four, not quite Ready for this assignment. My wife runs the the foredeck very well but I’m not fast enough to suggest...
Thanks I’ll give it a try
I cannot reach the further aft pencil zincs on my Volvo engines due to very narrow gap between this support post and the outer hull and equipment...
I have a similar question to add... On my 2000 450 Voyager the lower bathroom door leading into the forward cabin will not latch. the mechanism...
Thanks for tips. No I don’t have the used oil. I was too efficient this time and dumped it right away. At that time I did not pay attention...
Started annual maintenance last week on generator. Pump system pulled out used oil without a problem. Switched to pump oil back in and it would...
Thanks for replies Dan, your right. This model requires no zincs. A lot of worry put to bed
I have a 18 k Koehler generator on board I can’t seem to find where the pencil zinc is located The only manual on board is general use. Thanks...
