It was made of brass and what's left is very heavy. It was made by NIBCO. I made a manifold of copper just to get me through until I can get a...
On a recent short cruise, I went down to give the engine room a quick check. I saw water spraying on the ceiling and found the raw water manifold...
I have mechanical v10 820 actually 2840 LXE.
There are two senders just forward and below the oil filter housings. There is a third in the rear (I believe that’s oil temperature sender for...
I second what CR already mentioned, the gauge that's reading half is designed for single station application. Since your engine room remote...
I have a 53' so it could be different, but I have 2 VF breakers on the 12v side of the main panel. I had a defective breaker feeding on of them....
I had similar issue when I got the Ole Viking. Changed all sanitation hoses, and new vent. No joy. For me it turned out to be the bilge water....
No remote mounts standard filter mounting on both engines.
I laughed at the instructions too. Thanks for forwarding and if I can come across the digital LXE manuals I’ll forward to you. Cheers
Well I know when I check in the morning my starboard engine shows over full mark and port at full mark. When I check hot they’re both usually...
My Previous boat had 315 Cummins. I did all that work on my own engines and as stated above, about a day disassembly and bring home clean after...
Ok finally go to the boat. The manual says to check the oil “only after it has been shut down for about 5 minutes”, I only have the physical...
This might be the same. I'll check when I get back to the boat.
My operator's manual for v10 820's say to check the oil level 10 minutes after shutting down. If I check after 10 minutes, I always seem to be...
I once found a discontinued color of Corian counter (and a sink) on Ebay. You may have luck.
Make sure you shut hot water heater off if shutoff valve is in front of it...
BTW that is the newer style pump (garbage) sometimes you can still purchase the older style that hold up a little better.
Wow a little scary. I've had a few of those pumps fail and I keep a spare "in stock". I had a Rule -Mate 2000 do that once brand new but the...
FYI the SMX Pump uses a different impeller than the Sherwood pump. The SMX is splined and the Sherwood is Keyed. I had one of each at one point...
Thanks for sharing!
