I think she looks pretty nice, and as Chesapeake 46 said no riggers, or tower. To me I think the boat was not fished much, if at all. I think...
That is true, from what I read before going there. Only was there once, at the'' New'' Watch Hill national seashore marina. We had a great , both...
All I can say is I was a Watch Hill for a few great beach/ davis parks days, and I need 50amp 120 volt only and I had either two 30 amps into my...
Struts and rudders Buck Algonquin, shafts look up posts on here about that but, S/S hard stuff you will want. Props , find out what was installed...
You plug the exhausts to keep critters from getting into the pipes, motor etc and eating holes in things and or making a nest and causing damage....
Sounds Ok for 25/30 K. IMO. $50k is to high. Motors will need to start and run, along with sea trial and survey . To be sure they will need all...
So I just ordered a Rule LP900 low profile automatic bilge pump, I'm going to get that somewhere near or just directly aft of the bell...
Thank you all for the lesson and input on how a bell housing works on a marine inboard engine! I’ll further respond later on but right now I’m...
[ATTACH] Here is the build up coats, finish two coats went on next.
Sorry to say I could not bring myself to cut into my toe rails due to the following; the joints were all nice and tight/clean with no gaps and no...
Ok, I just thought it was more marine proof sealed up. I understand your point. I will work on keeping the water out and budget a new starter...
Is it possible then or normal ,in this situation, to get water in the bell housing? Or is there a way to seal it up?
Yes, not now! I know.
Not necessarily, maybe a tad harder at times. Depending where you want to go with the boat. But most places have dockage for a boat that size in...
Sounds good. You know ,the yard workers won't do as good a job as you will , cause it's not there boat and unfortunately many don't give a hoot...
It's only been almost a year since I brought up this question/post so thought I would give an update. All freeze out plugs are fine. I check...
Great news about the over heat issues. Man you Florida guys really have it bad with the sea growth. Here in Cape May it's not as bad. The...
Man...make sure that hull/deck joint and rub rail is addressed and done right, it's the most important part of the job, IMO. You don't want any...
Things I like to do when I get bored. Oh how I love getting this thing ready for varnish ! [ATTACH]
I used sweetie puss’s toothbrush one time ...I caught hell for that!! Anyway a stiff toothbrush did a good job to get in the little corners around...
