I couldn't help but notice that not a lot of hardware was removed, is this something new in industry? Or was this an ROI decision?
Sent you a PM.
You're probably not aware that with the RV version you can turn it off and pay nothing for the months that the boat is laid up.
I'm with J on this one, adjusting based on no dink on the bow might come back to bite you. I'm assuming you're leaving the crane and dink up there...
How much of the surface mounted stuff is being removed before painting?
That is really good ! Almost economical.
That certainly makes life easier. And quite honestly 18kts with that size boat is pretty darn good.
So basically under 10hours total and your good to go ?
How much break-in is required on that puppy?
Can you post a picture of the motor where it connects?
Have you looked at something like this? You'd need to probably add a customer seal plate over the motor but this would separate the two....
Www.McMaster.com McMaster-Carr Page: https://www.mcmaster.com/gas-spring-lifts
I bought my replacement at McMaster but that was 5 years ago so the actual one I bought is a memory. Measure the one you have, I'm guessing...
What are you looking for?
But is your friend an expert on 2 stroke DD's ?
We all saw them but they're made of metal and weigh a ton.
As well as Babcock is a new development that is built on raised lands and to BOCA specs, probably to minimum 175mph. They didn't lose power...
Yes, I discovered that this afternoon while trying to get around the I-75 closure at Port Charlotte. Total nightmare.
I 75 in the Port Charlotte area is closed due to a breached Dam. Apparently water running over highway. This will create some major traffic issues.
Interestingly we didn't get a lot of rain either, probably less than 4inches all day. Huge winds though
