Thank you all! I did send a note in... awaiting response..I really do like the unit.. hoping to figure it out as I have some long offshore runs...
I checked the 90 degree joint at the engine, greased them. Then disconnected each tach cable... they turn freely.... anything else I should check?
ran 3 hours on AP and everything was fine until about 2 minutes from home port - Port engine revved up, then went to almost idle - Starboard...
you can try - I would think they are chrome - use chrome polish. If too badly pitted, replace...
Excellent!!
Hey Lee, how you making out in your search?
is that the size of the screen or the whole filter? These were usually made by http://www.marinehardware.com/. take a look at this link, page...
As my boat is new to me, did some searching...I have the 40 open... mine is at the aft end, above the rear bilge....
I heard from Yanmar, the Napa oil is fine, no additives.... Just trying to do right by my girl!
Back in the water, here in NJ. Ready for a full season on Missy D.
Thank you, Sir!
Cool, thank you. Was just worried as I know gas flat lifters will wipe out the cam without zinc. I Jace a few antique cars and always add it.
I contacted Yanmar... great response.. they said no additives.. Cheers!
First time doing an oil change in my Yanmar 6CXM-GTE2. My last boat had flat tappet cam, so I used a Zinc additive to protect the cam. Do I use...
How's its this...
On my boat, looking at the Transom, there is a1" hole, and 2 screw holes above it, for the fish box drain. Trying to figure out what should be...
Hey Buddy! Taking the plunge!! Good luck, let me know what you get!
Was hoping to get something original...thx!
Looking to replace a missing boarding ladder for the transom door. Anyone able to send me a picture? Or better, know of one for sale! Thanks!
I like both these ideas!
