That could be easily machined from solid not cast, a pattern and all the expense in casting a one off is not really worth it in a simple part like...
Hi Folks, Long time since I have posted here, kind of kicking around the above mentioned boat. There is a little here and there on the forum...
This being the most viewed forum I ask this here, is anyone familiar with the delta and marinas in Uruguay and Argentina? I am going to look...
Yea, I have consulted with a few guys that have M117 AMG heads. When I worked at Ed Pink we dealt with a number of poor quality castings both...
I have a hard time keeping things "stock" the red SEC behind the wagon has an M-120 V12 in it!
I haven't been on here in ages, the forum sent me a link to this thread. My lil wagon is 2wd BUT, it has a 5.5 M113 kompressor driveline. [img]
Have you checked the point dwell? Steve
I did solo a Cherokee 140 before the D18 but, I fondly recall sitting in my fathers lap at a very young age bending the ole twin Beech around....
I knew Kyle's father Jimmy Franklin; perhaps the BEST airshow performer ever . If you guys are old enough to have been at airshows in the 1970's...
Great video, Nice air work particularly on the bridge:) Steve
Just to be clear, I was NOT advocating using a mis matched coolant, only to point out that any coolant mixture in the proper concentration of a...
The Detroit coolant would not reduce the temps in a normally operating system, you MAY see a few degrees from one coolant to another depending on...
Turbo/macerater pump, That would indeed give new meaning to the phrase, the turbo took a s**T. Personally I think the "electric chair"...
For your nest stripping job; use paint thinner to clean off the stripper instead of water, you won't have the issue with mold. You did a great...
Have you checked for exhaust restrictions in the underwater sections, from your description it is not a single point failure of a particular...
A million hours is over 114 years, continuous running, perhaps 100K hours? Steve
Gee, I don't have a clue huh, I have run major manufacturing plants with European, Asian and American machinery for nearly 25 years. I've had...
I agree that frequency sensitive equipment is an issue with 50/60Hz systems however, AC induction motors are not. Most AC induction motors are...
Old math? I just plain miss typed! The original poster mentioned dual 50/60 hz ratings, these should include the flow specs at each speed....
The difference in wiring for US and European 220~240 VAC is residential systems in the US are center tapped. One 110~120 volt leg is the inverse...
