Over loaded with booze, butts, lips,, certainly not enough to total one brain. Frak, sharks and crabs have to eat too......
The rubber against the hull, the board against a pile. [MEDIA] Not so fancy version; [ATTACH]
Don't drop Coastal Georgia or N/E Florida yet. We have nothing to do with central, south or the whole left coast of Florida. Two RingPower shops...
We are busting out in a few weeks for salt water. Not sure where yet; Tortugas or Abacos. We have not been to the Abacos since the big storm....
Finally a picture of what happened on the Ike.. [ATTACH]
Just the stick? Screw in or plug in with a snap/button? IMO Shurhold is the better snap/button handle.
Well, corn cobs don't work on decks that well. Other places, maybe O K.. What are you trying to clean and how soiled is it?
SFB.. I sheet you knot.. Luv ya brother but sometimes you worry me..
Pex is still rather rigid vs hose. Following contours inside hull / superstructure, joints and fittings in Pex behind panels may not be ideal,...
This is not good. You O K? Some drug scripts may help.
I was just about to ask about that. Naw, No wings or areo trim, only lift from the hull. Ya think a bit much??
Ohh Sheeeeet!!
[ATTACH] Also boring without my brothers here on Y F. Thank you brothers. ☺
We have to get back in salt water before I go nuts. Going to try and bust out mid/later May and head for the Tortugas again.. Where you heading?
Sometimes, those lil switches can just drive us fraking crazy. Good update. Hope al else is well.
Your assuming a check valve on both lines? Brother, Ya know this means squab. How long did that brand new MTU starter motor last after your rebuild?
The fluid stays in the cylinder, just leaks to the other side of the ram piston. [ATTACH]
I remember during the Shuttle launches, everybody knew what was going on. Schedules and hard yellow buoys were off-shore to help. I'm assuming...
If I recall, AIS boundaries are present during launches in the eastern range. Never witnessed these but figured they would be up soon enough for...
Then an internal piston leak is possible.
