That is really good ! Almost economical.
That certainly makes life easier. And quite honestly 18kts with that size boat is pretty darn good.
So basically under 10hours total and your good to go ?
How much break-in is required on that puppy?
Can you post a picture of the motor where it connects?
Have you looked at something like this? You'd need to probably add a customer seal plate over the motor but this would separate the two....
Www.McMaster.com McMaster-Carr Page: https://www.mcmaster.com/gas-spring-lifts
I bought my replacement at McMaster but that was 5 years ago so the actual one I bought is a memory. Measure the one you have, I'm guessing...
What are you looking for?
But is your friend an expert on 2 stroke DD's ?
We all saw them but they're made of metal and weigh a ton.
As well as Babcock is a new development that is built on raised lands and to BOCA specs, probably to minimum 175mph. They didn't lose power...
Yes, I discovered that this afternoon while trying to get around the I-75 closure at Port Charlotte. Total nightmare.
I 75 in the Port Charlotte area is closed due to a breached Dam. Apparently water running over highway. This will create some major traffic issues.
Interestingly we didn't get a lot of rain either, probably less than 4inches all day. Huge winds though
I'm 14miles up the Caloosahatchee and we have 4ft of water over the 6ft high wall. The flooding is going to far outweigh the wind damages. I just...
It's a pretty basic DIY repair. Buy a piece as described, cut to same size. If you want lay the old one on top for template, Hole saw the...
If he installed acrylic that's wrong material. Depending on size look for a piece of 1/4" thick GPO3 or similar fiberglass material, Lexan could...
New anticipated landing is Burnt Store / Charlotte Harbor. Cape Coral and Ft.Myers are screwed.
I suspect that removal, cleaning, sealing as required will solve your problem. The tank is fiberglass, the plate a composite of some sort, both...
