Reset the controller to factory default and running great! Thanks for the post jogged our thoughts to reset.
Like Hall Engine said, keep an eye on electrolysis or corrosion problems.
Check the two storage cabinets, one is behind the TV and the other behind the upper galley cabinets, had access doors in the stairwell. My...
My service manual dated 1/5/2015 for 3406E and c15 says clean and test aftercoolers every two years or 1000 hrs. whichever occurs first. Was told...
Did you contract with the total job with the installer? Have dealt with several contractors that have over booked work in the past year.
We switched power plugs, #2 unit is running good. If we don't get a fix soon will start another thread on this issue. Thanks
Thanks, the system controller is not turning #2 chiller on, if we cannot figure it out soon I'll be in touch.
Nobody in our area knows much about chillers., very few around. My current tech does standard ac's, electrical and generators. He is doing me a...
I hear ya... equipment and plumbing connections look good. Been months on ours and now on third tech if that makes you feel better...we are...
It did work, we had hardly any air to bleed.
We have a two gallon expansion tank which limits the amount we can pump in with the loop closed after lowering pressure. What about opening the...
Need to add glycol to the chiller loop. After doing a lot of bleeding to remove air in the loop plus adding make up water to pressure the loop the...
If the air handlers are 18 years old same as the chillers they may not be as efficient. We recently replaced all but one of our 17 year old air...
That 's it, standard off the shelf components. When you hear proprietary, get ready!
Aqua-Air gave us prompt technical service which help us thru several different problems we encountered. They also had equipment in stock with fast...
If your inner tubing that holds the Freon perforated like ours did it is not repairable, dumps the Freon out with the raw water. If the tubing...
Sounds like a good plan to me.
There is a lot of flexing going on at that cap connection. If a epoxy filler is not too brittle filling and drilling a new pilot hole could work....
Fill all of the screw holes with epoxy and offset the ss rubrail to drill new holes for fastening. Of course the same problem will occur over time...
When you think it can't get any worse.....guess what!
