cancel a trip due to whether What law school did you attend?:)
If they are Morse control heads The 4 screws are stops however the cables/ or linkage may cause the levers to stop before they get to the screws...
Get a 1/2" or larger counter-sink and drill out the screw holes. Not below the surface just widen the hole. You can fill the holes with vc...
http://www.yachtforums.com/forums/bering-yachts/15138-review-bering-yachts-55-steel-trawler-2.html Is anyone familiar with or have any...
I was thinking another company turbo'd the 3208 Cat when they first came out and they were rated at around 300hp. I can't recall the name of the...
If you're happy with the boats performance the 300hp version of the 3208 will give you better service. That engine originally put out 210 hp. At...
Sounds like Lubriplate assembly lube. I would rather use go-jo. Works like grease - dissolves like soap.
The area under the toe rail doesn't need to be filled. It will have sufficient strength from the channel iron shape. I would be tempted to use a/c...
I would use coosa board in place of the balsa core then cover that with 1 1/2 oz chopped mat. You need to grind the existing deck around the...
There is a tv special on the Discovery channel, Sunday at 9:00 pm central about the sinking.
Are you sure the bolts aren't countersunk in the strut and painted over? I've never seen a strut that wasn't bolted on with either a flat head...
When you approach the lock contact them by radio. They will tell you what they want and let you know about oncoming traffic, if any. Sometimes...
You need to find a knowledgable broker for advice. The boats you are looking at have obsolete engines (8-53's) that were not that great when they...
See what it turns up in neutral. That will tell you if it's governed. I'm not familiar with the boat but if it's a planing hull you need to run it...
Must be sealer for the screw. Zinc should be against bare metal. I've never seen a zinc fastener penetrate the bottom but, I haven't worked on...
I would be concerned about how the keel was attached after it was built. I thought it said 6 or 7 foot draft with a 40' water line length in the...
It depends if both engines turn the same and 1 reverses in the reduction gear. Most boat engines turn outboard looking at them from the rear....
If you have had to take out 2" of pitch And cut the Diameter 2" how much has the rpm's changed? What's the story on the engines? something doesn't...
I don't think he wants to increase diameter. He's going from a 555 with 2:1 to a 370 hp with 1.5:1 . I would be tempted to run what you have and...
Did the boat have 3208 Cats originally? I think those used to run a 19" prop. What do you have to start with?
