+1 Hard to get accurate unless both fins are below the keel, but you could tape plumb bobs from the front fin center line and the rear fin center...
+1 on the water quality. Engine manufacturers also have learned that the acidity or alkalinity (PH) as well as salts, can vary widely in the wild....
I am sorry for mis-characterizing you, at least in the first part of the subject sentence. I'll stand by the second part, and add "but sometimes a...
I would be tracking down user Mapism and begging him to contact either or both Azimut and Cantalupi. By phone. He loves the Azimuts and speaks the...
Cantalupi is reachable. Don't know how responsive, though. https://www.cantalupi.it
The trouble is that all the information we have is anecdotal and originates in hearsay. Including my advice :D As Dockmaster says: Where's the...
A lot depends on what kind of exhaust the engines have and the potential for condensation in the exhaust system. The most compelling issue is that...
Good one, Ed! :D
The trouble with some PropSpeed applications is that the metals are sometimes coarsely abraded so the coating has more "tooth" to adhere to. If...
I've delivered many boats that were either brand-new or recently sold. Many of them had no galley gear other than a microwave. No pots, pans, or...
I know you're replacing, the heads, but be sure and check the "Y" valves for blockage. I ran a yacht that had valves below the waterline, and...
Be sure and let the painter know what you used, and maybe supply the MSDS. The manufacturer lists Polydimethylsiloxane as an ingredient, which is...
I've seen that happen on a Detroit 8V92, where the T-bolt type of clamp that secures two parts of the exhaust flanges together simply broke and...
It's good to see a proper lookout posted on the bow. Not many do that.
Another possible improvement would be mounting a quality remote speaker in the overhead/headlining right above your better ear when standing at...
The uncleaned brush should be in plastic in the freezer next to the ice cream, though.
Could it have been arrival at waypoint? The gear we had on the last delivery did that. The plotter was Nobeltec TZ, though, but there's been a lot...
There's a lot of advancing technology on wrap material. I started to look into it at first as part of headlight restoration, and then progressed...
Thanks, Brian, good post. Turns out that Zuckerberg personally met with the President to put in his 2 cents on Tik Tok...
A good way to mount a transducer inside the hull is to site it first. If there are any air bubbles in the laminate, there will be a great loss of...
