Has anyone used the original Awl Grip on the exterior of a fiberglass hall? And how did it go? How was the quality of the actual finish (the...
Its going to be used in the waters of the Maldives. will be ready for around November....it's also a twin screw. i am becoming more and more...
Capt. Mike....what's ur take on the fuel consumption?
Looking at achieving around 17 to 18 knots cruising and a top speed of just over 20 plus.
Its a fiberglass hull....with a waterline length of 86 feet.
Capt. Mike....I would like to get some information on the fuel consumption of these engines at a couple of RPM ranges....is it possible? Thanks a lot.
Garry....since you have a vessel with these engines, can you give me some figures on the level of fuel consumption at a couple of engine speeds?...
thanks CODOG.....very precise explanation.....certainly very helpful!!
More minuses than pluses....??? Capt. Mike thanks for your input. its certainly reassuring to know that you have complete trust in them....but i...
Thanks Garry. That is most helpful.
I am looking at doing a Veedrive installation with a pair of 1450 hp engines with a max of 2300 RPM. But i have read that there is a loss of hp...
I am getting a pair of Detroit Diesel 16V-92TA DDEC engines of 1450bhp. Does anyone have any experience with this model of DD? if so i would...
MAN Used engines Hi BEKO, www.santekbv.com guys are very helpful too (based in the Netherlands) but they are certainly asking for very...
Anyone using MasterVolt Gensets? If so, what is your experience with them? I am looking at getting two 25 kW MasterVolt gensets. Thanks.
Has anyone heard of the Fitch Fuel Catalysts and had any experience with it or used it? If so, how did it go and did you have a good outcome?...
it was reassuring to read your experience nas130 but it appears that you have had some unpleasant experiences with the higher horsepower blocks,...
Thank you for your input K1W1.
I am looking at purchasing a pair of CAT 3412 E engines of 1200 hp @ 2300 RPM (D Rating) each. Has anyone had any experience with this engine...
Hi Everyone! Can anyone give me an indication as to what is a recommended minimum clearance between the propeller blade tip and the bottom of...
THANKS. will look at this website and also check with the manufacturers as well.
