Thanks for the help so far.
I sure wish there were someone who had the authoritative answer on this. Maybe another 56 owner might chime in or at least someone with Cats.
Did the good engine have to be off for this to work. Not sure why it would not grind the starter on an engine already running?
Thanks. Hopefully someone knows what was done on my model. Much appreciated.
Is it possible there is no way to parallel the batteries on my 56 if one bank goes dead. I would be surprised if Ocean did not think of that as an...
?
looking to install a CCTV camera underneath the overhang above the aft deck and have the wires run to the fly bridge bus bars under the steering...
One of the red idiot lights on the bridge for the bilge pumps and genset is out. It happens to be the one for the genset. Does anyone know...
It seems as if the starboard speaker in the starboard aft corner of the salon is shot. It appears to be in the wall behind a fabric covering. Does...
I have been able to source the potentiometer from a place in New Jersey. Thanks for all of the help. I intend to call them back and ask if they...
Thanks. I hope to give the 3 terminal pot a try assuming Vernon from Canyon does not have any original 5 terminal pots left. I do not have picture...
Thanks so much for sticking with me on this. I do not have a better picture than previously posted (and deleted by the admin). I can tell you that...
Does anyone know whey there are five terminals on the pot rather than the traditional three? There are only three wires going to it. Can I use a...
Thanks to all. Will report back when I have found the source.
Verified that pot is bad. Made by Vimar, I believe, and have several I need to replace. Any ideas where to find them would be great. They appear...
Found out it is a DRSA 20 amp dimmer buck puck. They no longer carry them. Their largest is 12 amp and cost about $150. I now need to figure out...
I will try to get to it tomorrow. Thanks.
It does. I guess I'll have to get a mirror and take some readings off the buck puck. Thanks for the help.
I tried to read them but they are illegible. I think the dimmer is connected to a buck puck but cannot gain access to that either. Sorry for the...
Not sure. Thinking 12vDC but can't get meter reading properly.
