I owned a '90 3207 back in the day. The water tanks were saddled on either side of the ER. They were connected with a 1/2 inch hose at the...
Thanks for the PDFs Capt Ralph. I have been reading most of the product descriptions from Centek. I do like the combo unit. It is something...
Another interesting setup.
Well, it does seem that I should give this idea more than just fleeting consideration. Thank you for all of your advice and experience. I think...
Yes, most of the gen sep units must be above the water line. I have had a peek at one of the installation manuals and I do belive I have the...
My Westerbeke 8.0 BTD currently exhausts through a lift muffler and out through the hull, above the water line. Previous boats I've owned have...
Ok, I was wondering about that. I will do that. Pretty sure the stuff will make it's way thru the duck bills as well with a couple of flushes.
The instructions indicate that the Noflex product is added, with water, through the evac fitting. But then there are comments and indications that...
All good suggestions. Thanks. Dometic makes many tank cleaners and tank treatment tabs. I'm assuming it's the one called "Tank Cleaner" which...
Roger, will do!
Thanks Cruz, I looked into this after reading your post. It is available in Canada so I will pick up a can of it and give it a go for sure.
For decades, I have simply used odour treatment in my holding tanks. Years ago, I stopped buying the expensive toilet paper and just used cheaper...
The battery banks on Sea Rays are labeled Port and Stbd for whatever reason. I've always preferred numbered banks. Anyway, the new port...
Update. I removed the output electrical cables, ground wire, the exhaust hose, two raw water hoses, three mounting bolts, loosened the fourth...
And that valve would be more secure than say the hose running from the pan to the valve manifold at the exchanger pump. It is tight at the pan...
I need to move it a bit more than 4 ". I would say 30 degrees or a little more. The engine end is to port. The fuel lines come in on the...
The electric pump is an interesting option. Thanks for the link. I was just at the boat and had a good look. There is no way the sea water pump...
I will know for sure once I change the impellor and repair the dripping hose connection. I may be able to stomach the service nightmare every few...
Another good idea. Of course wiring, water and fuel lines will need to be lengthened so there's slack. I will consider this as well. Perhaps...
MBevins: 180 rotation would move the oil filter, fuel filter, dip stick, primer solenoid etc to the backside. Bigger problems than I have now....
