Click for Mulder Click for Perko Click for Walker Click for Mulder Click for Burger

When Do I Move The Fuel Selector? Carver 330 Mariner

Discussion in 'Carver Yacht' started by snelltyke11, Jun 28, 2013.

You need to be registered and signed in to view this content.
  1. snelltyke11, Jun 28, 2013
    #1
    snelltyke11

    snelltyke11 New Member

    Joined:
    Feb 18, 2013
    Messages:
    30
    Location:
    Atlanta
    Hey Guys,

    I want to move both engines to the starboard tank and use the generator off the port tank.

    When do I move the selector switch? While running or before start?

    What do you think? What has been your experience?

    I have 3 manual knobs under the dinette...

    Thank you!
  2. Pascal, Jun 28, 2013
    #2
    Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,527
    Location:
    Miami, FL
    Doesn't matter... You can do it running or stopped.
  3. tommyfmu, Jun 29, 2013
    #3
    tommyfmu

    tommyfmu Member

    Joined:
    Jul 1, 2010
    Messages:
    95
    Location:
    Freeport, NY
    Yea, as Pascal said it doesn't matter when you change tank selection. Just wondering why, and is it going to be normally set that way? Not sure about your boat, but the generator fuel pick up is normally higher in the tank so it would never cause you to run out of fuel I think, if that is a concern. What you might get is listing though as the weight becomes uneven between tanks. Just today I was noticing a 4 deg list towards stbd because the tank was full, and port was 3/4, so I selected stbd tank for both engines and genny until they're even again.