Click for Perko Click for YF Listing Service Click for Westport Click for Ocean Alexander Click for Mulder

Transmission Problems

Discussion in 'Technical Discussion' started by FIQ, Apr 26, 2016.

You need to be registered and signed in to view this content.
  1. FIQ, Apr 26, 2016
    #1
    FIQ

    FIQ Member

    Joined:
    Feb 19, 2016
    Messages:
    60
    Location:
    Olympia, Wa
    I'm having the shafts and props checked and trued along with new cutlass bearings and dripless seals installed.

    However, when the shaft was removed from the port side, the output flange had lots of play up, down, and laterally. No noise or oil leaks.

    The transmission is a ZF IRM301A1.

    I'm wondering if anyone else had this problem.

    Could I just remove the back housing and repair, or do I have to yard her out?

    I've been trying to locate an exploded view picture but have yet to locate one.

    Thanks
  2. FIQ, Apr 30, 2016
    #2
    FIQ

    FIQ Member

    Joined:
    Feb 19, 2016
    Messages:
    60
    Location:
    Olympia, Wa
    OK...It looks like the port shaft is bent along with the damaged output flange on the transmission. I'm going to turn it over to my insurance.