Click for Northern Lights Click for Glendinning Click for Westport Click for Burger Click for YF Listing Service

Power Steering Filter

Discussion in 'Technical Discussion' started by CSkipR, Nov 20, 2019.

You need to be registered and signed in to view this content.
  1. CSkipR, Nov 20, 2019
    #1
    CSkipR

    CSkipR Member

    Joined:
    Aug 16, 2008
    Messages:
    965
    Location:
    New Smyrna Beach, Fl
    I need to change my power steering hydraulic filter. After removing old filter should I fill the new filter up with power steering fluid and then screw it on or leave unfilled and put power steering fluid in the pressurized cylinder after releasing pressure. Thanks
  2. Beau, Nov 20, 2019
    #2
    Beau

    Beau Senior Member

    Joined:
    Jan 15, 2010
    Messages:
    2,261
    Location:
    Beaufort, NC
    fill the filter to reduce the air you will be introducing into the system. You'll have to run the helm pin to pin a couple of time then check the pressure and fluid level in the ER cannister. Keep a watch each time you check your engine oil.
  3. Capt J, Nov 21, 2019
    #3
    Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,531
    Location:
    Fort Lauderdale
    Also since your boat has a power steering pump, make sure the engines are running when you turn the wheel lock to lock several times.