Congrats. I’ll send you a PM to see if we can meet before you take off for the East Side. Our boats “wintered” together in the shed last winter...
To be clear, I am attempting to fill 5 dozen #10 screw holes that are in factory gelcoat that has never seen the light of day. Sealed and covered...
Thanks for the tip. I am actually looking for pre-mixed gelcoat or gelcoat putty that matches the factory color from Post. When we pull the teak...
We’d like to remove the half round teak trim from the deckhouse on our ‘85. Spectrum Color offers quarts/gallons of Post “Old White” gel. They do...
By chance are you buying the 1986 46 that’s slipped in Muskegon, MI?
@FencingAg - what’s the status, did you pass on making an offer? +1 for everything that’s been written above. If you haven’t done so already,...
If I could relocate the forward air compressor / air handler, I’d squeeze in a 50-60 gallon holding tank under the bed.
@Greg Page - is your MKII 43’ a forward MSTR? Both AC compressors in the engine room? Original units? Good call on the Elegance. I liked your...
Has anyone replaced the blackwater holding tank on a 43 (or similar) located in the dresser cabinet below the forward birth? The current tank is...
Our dockside water inlet water pressure regulator (40 psi) called it quits this week. Is the unit pictured below standard/original equipment on...
Fantastic. Do you know if the lengths refer to the total length eye to eye with the hook in the middle or length of the eye to the hook (per...
Looking to get feedback and suggestions for rigging a bridle to ease tension on the windlass on my 43’ that is currently running the original...
That’s ok. Thank you for uploading the photos. After reviewing, I realized that we need a sofa frame frame out of a Gen 1 43 or potentially a Gen...
i just sent a note.
@Greg Page - is the outgoing unit’s frame salvageable? We have a pullout love/seat sofa that doesn’t fit at all that the prior owner put in....
Did the Futon couch project take shape this winter? I’m keen to see photos of how it all came together.
Bingo. Thanks @MBevins
Thanks for the replies. I’m looking for the same or as close to the “same” vinyl/rubber sheet material that originally came from PMC in the 80s...
Does anyone have a material spec or product recommendation for replacing the cockpit scupper flaps on the transom?
Thanks. I just placed an order with Poseidon.