No, was putting back an identical bulb. But if fixtures are starting to go bad thought I might upgrade to led’s. I’ll check this out. Thanks
I have 8 one bulb fluorescent light fixtures in my engine room one quit working so I replaced the bulb. It only partially lit and within a couple...
My mistake. Can’t get hold of Bomar!
I have a 23 inch round hatch on the bow of our 450 Voyager. Grand daughter damaged the locking mechanism that holds the hatch open. I’ve found...
Thanks for input. I can measure the length and start with searching that weight capacity. what is the proper name of this piece ?
It is the piston that helps hold the weight of the crane. It assists with lifting the crane from the storage position into the lifting position,...
I just reposted my search for these parts. Sorry, I could not this original post. I finally got parts removed from the crane and there are no...
So my Brower 600 lb crane piston that assists with manually lift and lower crane arm into position has quit assisting. Any idea where to buy...
This is a carver 450 voyager. 2000 you can see in this photo that the shaft does not look pitted to me. I think this should clean up. Guess I...
I hate to be a painKSBGUY but I’m having trouble visualizing how the jack is going to push the seal in straight. Any photos of when you did...
Here is a photo [ATTACH]
I own a 2000 Carver 450 voyager. On the swim step are two lockers on the transom? (Not the two located on the swim step itself). Anyone know...
Two deck fittings. yes one pump for both tanks. You select by moving the diverter valve to either port or starboard. Located on the forward...
Recently moved to a new dock that provides fitting for pump out in our slip. in past years I paid for the service as I did not want to pump...
Wow Capt Ralph. A little more negative answer than I expected. I know Carver is not an ocean crossing exploration trawler, but my OA or...
I am experiencing slight leakage around both rudder posts. Very minor amount. About a quart on a two hour run. While in the water, I have...
[ATTACH]
My 450. Voyager fresh water monitor has never been very accurate. When filling needle would stick. A little tap and gauge would move. now it...
Never got any suggestions. What we wound up doing was curing it off clean next to the metal trim. We then taped off about1/2 inch away from...
[ATTACH] Well I found something. This area now has one additional through hull for bait tank. The bulk head I want to cut shows the scupper on...