I put one on my Voyager. My vent hose runs uphill from the tank, so overfilling the tank would require it being so full that it spilled upward and...
This is the place I use. Not sure how your prices compare. A.S.A.P.
Another idea which worked for me was using an electricians fish tape. It's rigid enough to pass the other cables and ie easily retrieved. I found...
Because that's the lowest point of the boat when settled in the water. The aft is actually a bit more shallow than midship is.
Check logs on the last dates/hours of filter changes Is there a fuel cleaner aboard? Fuel, water, oil leaks Injector status? Any recent service...
Adding a transom shower is pretty straight forward. Access to the water lines is in the aft portion of the bilge. Usually, there are 15mm plastic...
My 37' is equipped with one. When not in open water, the CG wants the seacock handle fixed in the closed position...usually a wire tie is sufficient.
Doesn't necessarily mean that it has one. As stated, start at the tank and look for a 1.5"-2" hose coming from the lower portion of the tank. If...
Paint with AwlGrip. Best money I've ever spent on mine. No waxing and it takes about 30 minutes to wash the entire boat.
At least they'll know where the boat is when they're ready to try moving it again. :rolleyes:
You shouldn't have a problem with the water freezing because it isn't static. It's constantly moving even tho it's cooled below the freezing...
Being a 27 year old boat, I wouldn't put any significant live load on the hard top. You might have to comb thru some older literature to find out...
For peace of mind, don't automatically assume it's the panel. Start with the beginning and work your way to the panel. Dock power stantion, then...
CSkipR - being in NSB, your block heaters really shouldn't be necessary at all. Even if, during the winter, the ambient air temp drops into the...
Dynamat has an approved temp rating of +300ºF, but it's up to the OP as to whether or not it's for him.
Most DIY box stores carry a similiar material, or you could even switch to the white foam backed panels. All are very flexible. Another solution...
Thin stamped steel works well, especially if you have it powdercoated against corrosion. I had a dash panel made over 10 years ago on a saltwater...
I have always used dish soap. Aside from the lubrication ability, I also find out that it tends to clean out a little gunk when run thru the water...
If you want to use AwlGrip, you can also apply it with a small flat knapp roller. It takes about 5-7 hours to flash the paint, but in the...
Are you having the same problem when running from the genset? If not, it's probably not your panel, but the electrical feed from shore power. If...
