I am calling 408Vac at your slip un-usual also. Anybody tested with a volt meter yet?
I have made adapters for dockside 100A-4 pin to twin 50A boat service that worked very well. I have made adapters for dockside 100A-5 pin to...
I recall the 4 pin is used as a single phase. Ground, Neutral, Top Vac, Bottom Vac (green, white, red, black). The 208Vac you are reading is the...
Your training captain probably has a tall tonnage ticket. Past 200 does require endorsements on lots of topics. Not just for USCG but SOLAS & IMO...
Pretty ole girl. Shame is, she looks better than some of the woodies around Jax now. Does she have the triangle bath tub up forward?
Interesting video. They keep mentioning to refer to the manual for instructions on the plumbing setup. Also, Please listen in on the audio...
Are you looking for custom, new or used?
Check air hose and clamps between turbo, inter-cooler & blower. Take air filters off. Check turbo for cracks and air leaks. As I expressed on...
Oh, Ensure shut down flapper is all open.
When did this problem start? Overnight or thru the years? Any history? Black Smoke = Not Enough Air..
I'm a little concerned that the shaft may not be strong/safe enough for a 5 blade wheel. I don't recall a shaft rating mentioned.
We all do.. :)
IMO, Fire your marine mechanic. He just wasted a lot of your money. Now you have a more complicated carb installed, performance may not match the...
As you have pointed out many times before, there is no access from the deck to recall the fenders on some new designs. Further issues include SFB...
Heat on the shaft, Replace that front seal for sure now..
Pascal was here before on his previous work boat when he took it over. Fresh sensors all around I recall took care of it. I remember going around...
I had to download one of the original pictures from above and zoom it in real big. Post #1, JPG #2 The negative leads etches are tied. 2 wires to...
On power on, it assumes the feedback unit is there, but when it moves the rudder and no change in feedback value, it logs the error. Depending on...
Usually not much iron for a magnetic dial base to mount on in a bilge. I use a heavy scrap iron plate sitting in the bilge. Also had a metal tab...
Very good point. Never allow your gen-set thru hull water to be forced or scooped into it's raw water system.
