1.5 hours at WOT????? I have done a 100 new engine start ups with CAT, never ever have I run wide open more than 10 minutes. The C 18 Acert...
That is the typical size of a galley on most 80' MY's I've seen. Even the old Hatteras'. Take a look at a late 2000s 72' Hatteras MY or 2003 or...
But I don't see any failures on the MAN aftercoolers or Cummins or others. I manage a 2007 yacht with MAN 1100 common rails right now, never been...
I'd be looking to pay in the 500's personally. Several things come to mind on the boat. The 92's are right around the corner from major...
They do, it's about $4500 per motor so I've been told. It still utilizes the upside down metal filter cartridge housings that you have to take...
And ease of maintenance as all of the CAT filters are spin on (secondaries, oil filters), and almost all CAT boats have the filters right in the...
Mapism was talking about ID also. The ID of the hose or pipe restricts flow far worse than what a fitting does. That is what I was getting at....
If it’s new and never used. I doubt sitting around for 5 years would hurt it
When taking about any pipes for water, all relevant measurements are always spoken about in I.D., not O.D.
Then what are the D2876 LE423s, from the photos they're inline 6 cylinders? They're listed at 800 HP and in a 2007, 43' cabo that is for sale. I...
I ran a set of Covington 12v71 TI's and they had 120's with 1.46" injector height. Motors ran very good and extremely clean at cruise.
I disagree. I have worked full time on several yachts early on. Got paid very well. One of them I worked 2.5 days a week in 2004 as a mate and...
I'd be looking at the Sunseeker Manhattan. The 55' Princess fly would also meet your needs at a higher price point and my preference would still...
Alexseal is a 2 part Eurethane but from what I've seen, never cures as hard as Awlgrip or Awlcraft and therefore is less abrasion resistant. It...
What are your top 5 needs and top 5 would be nice to have's in a 50' MY?
Normally you would put teak right over that, for 2 reasons so any water flow off the side decks hits the fiberglass as usual instead of hammering...
What I am trying to explain is due to the length of your runs, slightly larger I.D. pipe would give you a little less restriction over many feet...
Pacblue, Thank you for clarifying that for everyone. I recently delivered a 2007 40' Cabo flybridge with 800 Man's which made me think they were...
PM Pascal, the grove is his home turf and I'm sure he knows someone down there.
3" hose is 3" I.D. not O.D., stepping up the size of your hard piping to 3" I.D. , even if you keep the 2.5" seacock will still increase water...
