I read 2:19 p.m. I did not read 0219 for the time of event. So, daylight hours a 154' cutter "collides" with a 23' fishing boat. This is not...
U.S. Coast Guard Cutter Involved in Fatal Collision with Fishing Boat Off Puerto Rico Mike Schuler A U.S. Coast Guard cutter was involved in a...
For the OP, time to get in sync with your boat. Start following hoses and figure it out.
Please tell me you just made that up. Who in their rite mind would deliver a boat with that set up? Carver would not step that low. I used to...
If that is a factory dash, call Viking with your HIN. https://********************/main/ContactUs.asp //vikingyachts dot com/
Follow the wires. I'm SWAGing, Windlass contactor box.
How does the stb door stay in place? Have you tried to contact Marine Max yet?
I was hoping some Mut owners would chime in but, not yet. While were waiting, can you send some pictures of the door, latches and description of...
Well,,,, Where are the pictures of this great work?? :rolleyes::rolleyes:
The 60s had exhaust leak issues before and at the turbo. Not all expanding gasses going to the turbo,, slow turbo,, low air and soot/dark exhaust....
Ug. How can you tell in "off position"? I have similar valves, but not in that pretzel fashion. In your picture, the valves are not closed,...
3 fresh water fills???? Follow one of them down to the black water tank.
Unless you know a trick, those seals must have the shaft / coupler separated to replace that seal.
That ping or tink could have come from anything including your pull bar. The real test it to pull it over past 2 revs. Put a pipe on a pull bar....
OR,, the horn is bad and pulling B+ down. Put a light on the leads with horn disconnected and watch if B+ stays up or drops. If it drops, start...
Sweet and clean. A thought; Your water injection to the shaft log seal assembly, that street 90 and nipple, Is that brass or bronze? Maybe...
The 15:1 piston was used on the 6V92 TIA. These have been recently been rebuilt by members on YF. Are you dealing with a real Detroit Shop?
Are you ordering parts by engine serial number? Is this the DDEC 6V92TIA? What does Detroit recommend?
With a DDC part number on it? With liners?
So, what are you going to use for a liner? If it is an obsolete part, what does Detroit recommend?
