Click for YF Listing Service Click for Abeking Click for Westport Click for Perko Click for Cross

Transom angle 1969 38' Roamer

Discussion in 'Chris Craft Roamer Yacht' started by jflongwell, Apr 20, 2009.

You need to be registered and signed in to view this content.
  1. jflongwell, Apr 20, 2009
    #1
    jflongwell

    jflongwell Member

    Joined:
    Aug 27, 2008
    Messages:
    57
    Location:
    Watkins Glen on Seneca Lake
    I am putting a swim platform onto my 38' 1969 Roamer.
    The transom tilts forward and I am trying to determine the angle to make the braces to. I have figured the transom is at about a 8 degree angle. Any one know a definite figure?

    John
  2. Ken Bracewell, Apr 20, 2009
    #2
    Ken Bracewell

    Ken Bracewell Senior Member

    Joined:
    Feb 9, 2006
    Messages:
    1,769
    Location:
    Somewhere Sunny
    You could always make up the difference with wooden wedges.
  3. jflongwell, Apr 20, 2009
    #3
    jflongwell

    jflongwell Member

    Joined:
    Aug 27, 2008
    Messages:
    57
    Location:
    Watkins Glen on Seneca Lake
    Swim platform

    I am not sure if that would hold very well. I am having the brackets modified with an 82 degree angle. I am bolting the platform to the transom with 1/4" SS bolts. Do you think these are sufficient? Getting to the transom with the water tank there is a real pain!!!
    John
  4. Ken Bracewell, Apr 20, 2009
    #4
    Ken Bracewell

    Ken Bracewell Senior Member

    Joined:
    Feb 9, 2006
    Messages:
    1,769
    Location:
    Somewhere Sunny
    You would bolt right through the wood, using them as spacers. This will also help to alleviate dissimilar metal reactions.
  5. q240z, Apr 22, 2009
    #5
    q240z

    q240z New Member

    Joined:
    Oct 24, 2007
    Messages:
    285
    Location:
    zsedr
    The swim platform on my 46 Roamer is enormous and used mahogany spacers as Mr. Bracewell has described. The platform is made of stainless, as are the 3/8" bolts. I will use the same mahogany spacer approach when I mount mine, but will cold mold them by saturating them in epoxy before painting them with the appropriate top coat or bottom paint.