1985 Carver 3607 Exhaust Hose Replacement

I need to replace the exhaust hose that runs under the aft cabin floor. The hose runs under the cabinets on the starboard side of the vessel. I will have to replace the Port side in the future. I have done a lot of repairs over the 10 years I've owned the Carver. It seems like Carver on the 3607 made access to get to systems for repair or replacements. Has anybody replaced the exhaust hoses in the past? It looks like I can take the cabinets apart as they are screwed together. Unless they are glued and then screwed together. Thank you

Thanks for the information, I'm going up to the lake this weekend to look the project over

I was able to remove the cabinetry by removing a Lot of screws and brackets. Taking the L section apart, the whole piece came out. Then fit through the door way going into the salon. Under the liner the cabinets was sitting on. There is a plywood access cover to the bilge and the hose. The port side I was told to remove the seat in the bath tub. There is access to the hose where it attaches to the bulkhead.

I'm going to add more of how the portside exhaust hose replacement is going. Under the cabinets there is 3/4 inch plywood covering the raised part on the cabin sole(floor). The plywood cover is screwed on the inside. On the outside it is glassed to the hull. I'm going to have to very carefully cut the fiberglass matting that attaches the panel to the hull. Then after the hose is replaced. Glass back in the cover over the exhaust hose. The vent hose for the aft head holding tank is now exposed. Then the hoses from the engine to the hot water heater heat exchanger. I will replace all 3 hoses while they are exposed.