Click for Glendinning Click for Northern Lights Click for JetForums Click for Delta Click for Mulder

Cockpit refrigeration?

Discussion in 'Technical Discussion' started by praetorian47, Aug 27, 2018.

You need to be registered and signed in to view this content.
  1. praetorian47, Aug 27, 2018
    #1
    praetorian47

    praetorian47 Senior Member

    Joined:
    Aug 22, 2011
    Messages:
    258
    Location:
    Bayport, Midland, Ontario
    my ‘88 Ocean 55SS has a freezer on the cockpit next to the engine room. Originally for fish, but now for beer, and what a job it does! I can hold well over 100 cans and they are ice cold. The first issue is insulation, I get a lot of moisture and need to thaw it out and clean it a few times a year. Not a dealbreaker, but annoying. The real issue is power draw and noise. It’s got coils running around the box and a compressor below. It runs off the inverter when off the dock, but it’s noisy when I’d like quiet.

    I figured this was just the way it was but an ac guy was over last week working on a air con issue and told me these are loud and power hungry and I could put a large cold plate covering 3 sides of the box and it would work just as well but quiet and less energy.

    Any idea or advice?
  2. MBevins, Aug 27, 2018
    #2
    MBevins

    MBevins Senior Member

    Joined:
    May 23, 2008
    Messages:
    1,225
    Location:
    Windsor On. Canada
    Besides asking him for a quote to do it.
    That technology has been around for a while
  3. Capt Fred, Aug 28, 2018
    #3
    Capt Fred

    Capt Fred Senior Member

    Joined:
    Jun 22, 2009
    Messages:
    319
    Location:
    Long Beach CA
    A few comments, agree that it is a power hog, and that there is no frost free mode but you may want to reduce the temp to prevent freezing and the condensation should drain to the bilge. I have a Cruiseair unit in my boat and it is not noisy, I can barely hear it running when engines and genset are off. Perhaps the fan is rubbing against something. If you do decide to upgrade, please let me have first dibs on your old compressor unit.
  4. PtJudeRI, Sep 3, 2018
    #4
    PtJudeRI

    PtJudeRI Senior Member

    Joined:
    Dec 1, 2010
    Messages:
    153
    Location:
    Pt. Judith, RI
    The chiller plates are nice, but the setup is expensive. I was quoted around $7k to do my boxes. I can live with the AC noise...
  5. Capt J, Sep 3, 2018
    #5
    Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,531
    Location:
    Fort Lauderdale
    Plus the stuff against the plates freezes and the stuff in the middle is half cold when you stuff them with your 100 bottles of beer. Insulate the lid with a nice thick but very soft gasket and should help with condensation.
  6. praetorian47, Sep 3, 2018
    #6
    praetorian47

    praetorian47 Senior Member

    Joined:
    Aug 22, 2011
    Messages:
    258
    Location:
    Bayport, Midland, Ontario
    Thats what I was afraid of. I tried a gasket already and it made the condensation much worse. I think better insulation on top might help, and then the gasket may work.

    I can't argue the performance of the existing unit. Beer is just perfect! Barely liquid, very refreshing on a hot day ')
  7. Capt Ralph, Sep 3, 2018
    #7
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,442
    Location:
    Satsuma, FL
    Can you explain where the condensation is again in or outside the box?
    Exposed coils around the in or out side of the box?
    Has the rubber compressor mounts faded away?
    Tried a gasket and condensation worse?
  8. praetorian47, Sep 3, 2018
    #8
    praetorian47

    praetorian47 Senior Member

    Joined:
    Aug 22, 2011
    Messages:
    258
    Location:
    Bayport, Midland, Ontario
    Condensation is inside the box, there are no exposed coils. They are wrapped around the box interior.

    Could the issue be poor insulation on the top of the box?
  9. Capt Ralph, Sep 4, 2018
    #9
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,442
    Location:
    Satsuma, FL
    If it's wet when you open it, well yes.

    Wish we had some pictures of everything.
  10. praetorian47, Sep 4, 2018
    #10
    praetorian47

    praetorian47 Senior Member

    Joined:
    Aug 22, 2011
    Messages:
    258
    Location:
    Bayport, Midland, Ontario
    I’ll take pictures tomorrow and post them, thanks!