Click for Cross Click for Delta Click for Furuno Click for Burger Click for JetForums

Can you tow a propped tender?

Discussion in 'General Yachting Discussion' started by Danvilletim, Feb 11, 2018.

You need to be registered and signed in to view this content.
  1. Danvilletim

    Danvilletim Senior Member

    Joined:
    Oct 30, 2011
    Messages:
    794
    Location:
    isleton, ca
    I ve seen plenty of larger center consoles towed behind 80-90 MY. How about 36' cosair chris craft?
  2. captholli

    captholli Senior Member

    Joined:
    Jan 4, 2010
    Messages:
    1,184
    Location:
    In The Bilge
    Yes, absolutely. Have a nice big stainless custom towing eye with backing plates installed and tilt the bravo drives up and tow away. The Corsairs are fantastic boats but they don't make good tenders as their a bit to luxuriously fragile interior and cockpit wise to take the constant wear and tear of scrubbing off the carbon and exhaust soot after each tow. The sophistication of systems just don't take well to the pounding and salt water incursion that towed tenders encounter The enclosed bow or foredeck make hooking and getting crew on or off any type of sea is down right dangerous. Beautiful boats, lousy tenders.
  3. Danvilletim

    Danvilletim Senior Member

    Joined:
    Oct 30, 2011
    Messages:
    794
    Location:
    isleton, ca
    Thanks for the feedback. Your response makes sense.
  4. Danvilletim

    Danvilletim Senior Member

    Joined:
    Oct 30, 2011
    Messages:
    794
    Location:
    isleton, ca
    My thought was that the 36 cosair would provide pretty nice extra crew accommodations. You give up an open bow, but better than most crew accomadtions than most euro 80-88'
  5. captholli

    captholli Senior Member

    Joined:
    Jan 4, 2010
    Messages:
    1,184
    Location:
    In The Bilge
    I towed a Monte Carlo Offshorer for a year and it was a beautiful boat but a beast to handle close in with the big boat. It took a minimum of three crew to keep it from eating the stern of the big boats swim platform during payout on the towing hawser and to haul in on the stern winches and unhook to bring alongside to the whips. After one season the interior bolsters and cockpit panels had to be replaced from the constant cleanings . More than a couple of times I had damage to both boats and a couple of crew injured from a 32ft boat plus I had to have one crewperson dedicated fulltime to that tender to keep it clean, perform mechanical maint. and keep it in shape for guests. It was great to have on certain occasions but tenders of these dimensions belong in garages with overhead gantry cranes .
  6. 1000 islands

    1000 islands Member

    Joined:
    Apr 20, 2013
    Messages:
    203
    Location:
    Ivy Lea
    What about towing a SeaDoo Sportster...I picked one up with the idea of using it as a dinghy.

    My concern is about how far it should be behind the boat while under tow.

    Has anyone ever do this ?
  7. Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,440
    Location:
    Satsuma, FL
    On a 34 I owned long ago, I used a long moor whip pointing aft.
    A painter was tied to my stern cleat, to the whips tip and then 4-5 feet to the wet-bike's tow eye.
    Underway or at anchor the Sea-Doo never hit my swim platform and towed well.

    On a larger or faster boat, some more scope and adjustments may be needed.
  8. Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,531
    Location:
    Fort Lauderdale
    100' I would think as it has no drag to speak of. You will need to install water shut off valves since it is jet powered and towing it with any speed at all will flood the motors on it and fill them up with water. You can create drag by towing 10' of decent sized anchor chain in the water behind it with 10' of rope to a stern cleat. This will help it track straight.
  9. skipperguy

    skipperguy New Member

    Joined:
    Jun 6, 2007
    Messages:
    1
    Location:
    Crew's Inn, Hamburg Cove
    i towed a 13' whaler with 30hp outboard for 20 years. 10 knots cruise on my trawler-no problem
  10. CTdave

    CTdave Senior Member

    Joined:
    Mar 21, 2004
    Messages:
    876
    Location:
    Greenwich CT/ Stuart FL
    I tow my 17' Whaler from my 50 Hatteras at 28-30kts regularly. I tilt the engine so the skeg is in the water so it traks straignt & about 100' out. The problem is when the weather goes downhill and you will have to reduce speed so the tender isn't taking a pounding. Hah, I just remembered a funny lol. We were towing our 6 or 8' Rib along one day from our older Post. My 4 year old son at the time looked back and said "dad, where's the engine". LOL!! The bouncing made it work it's way off because it had the hand crank down mount vs. bolted.
  11. ychtcptn

    ychtcptn Senior Member

    Joined:
    Jul 8, 2005
    Messages:
    513
    Location:
    Lighthouse Point, FL
    Off the original subject.

    I was told by Mercury outboards to never tow with the engines down per the request of the insurance company, the thrust bearing are not made for the much reverse torque over long periods of time.

    If you are towing smaller whaler and the such, but a line thru the aft center drain and run about 20' of line out with a loop, this will make it tow nice and straight. We learned the hard way with an 11' behind a 28' Bertram, the thing flipped right over! Oops!
  12. GhostriderIII

    GhostriderIII Senior Member

    Joined:
    May 8, 2015
    Messages:
    350
    Location:
    Newfoundland
    I've towed several boats (not as same time) but with motors up and over.