Click for Perko Click for Abeking Click for Furuno Click for Cross Click for Westport

Fresh water pump

Discussion in 'Technical Discussion' started by Fdemelo, May 31, 2016.

You need to be registered and signed in to view this content.
  1. Fdemelo, May 31, 2016
    #1
    Fdemelo

    Fdemelo New Member

    Joined:
    May 31, 2016
    Messages:
    1
    Location:
    Massachussets
    HI
    I have a 2003 52' tiara with a water pump problem. don't know if its because of the water pressure at the dock but its leaking at every connection and it wont pump water when im not hooked up.
    any ideas what it might be?
  2. Maxwell, May 31, 2016
    #2
    Maxwell

    Maxwell Senior Member

    Joined:
    Sep 16, 2010
    Messages:
    195
    Location:
    Door County, WI
    I believe that boat has some sort of expansion tank in the system. The fact that its leaking at every connection when hooked up to dock water would tell me that it can't build the pressure enough to actually pump water to the faucets on its own. I'd suggest fixing all of the leaky fittings and try again.

    max
  3. Lepke, May 31, 2016
    #3
    Lepke

    Lepke Member

    Joined:
    Dec 26, 2015
    Messages:
    123
    Location:
    US West Coast. Cruise NW Passage to Alaska.
    If you have leaks on the suction side, it's easier to suck air than water. So the pump can't pull water because the air pulled into the suction plumbing breaks suction. If shore water flows thru the pump, the leaks could be from excessive shore water pressure. My water connection to shore comes after the pump, so the pump isn't used in port unless I am running off the tanks.
    As above, fix the leaks. Take a pressure reading of shore water. You must have an expansion tank after the pump. Make sure the bladder pressure is correct. Opening a faucet can help the pump get initial suction.
  4. ranger58sb, Jun 1, 2016
    #4
    ranger58sb

    ranger58sb Senior member

    Joined:
    Aug 20, 2013
    Messages:
    897
    Location:
    Chesapeake Bay, USA
    Our pump isn't in use when we're hooked up to a dockside water supply.

    If it won't pump from the onboard tanks... without regard to leaks... could also be a failed pump... or failed electrical connections... or a failed breaker... or a breaker not turned on...



    Our freshwater pump only has two connections, an innie and an outie.

    It happens ours are the QEST snap-in connectors; if those are loose (un-snapped) for some reason, the connection isn't sealed. If your pump has those kinds of connectors, check to see they're fully inserted into their track.

    Or... another style of connection can be simple hose clamps. It should be easy enough to see if those are tight.

    -Chris
  5. Txcruiser, Jun 6, 2016
    #5
    Txcruiser

    Txcruiser New Member

    Joined:
    Jul 24, 2014
    Messages:
    8
    Location:
    Texas
    Maybe I am missing something but if you are connected to dock water the onboard pressure water pump will not operate. It is intended to pump only when disconnected from shore water. I just replaced my pump with a new Johnson variable speed pump that is a little higher capacity and pressure. I don't have an expansion tank. Bought the pump on
    Amazon.