Systems status panel

What engines are you dealing with?

Ah....I was thinking of people who provide systems, not panels only. The ones I know who are capable aren't going to do a project that small. People like Crestron will program anything. You might check with them. They might be able to refer you somewhere if they won't do it. MTU offers it but again part of MTU systems.

Most Yacht builders made their own, Westship, Westport, etc. Either that or they are made by another manufacturer with the Yacht Builders name silk screened on it. I'm guessing a google search will answer your question. If not contact Marine Electronic Installation, they'll be able to find you one.

I've replaced an original panel with boat outlines, bilge pump, nav light, and other tell tales on a Riviera 58 made by Technografic in Fort Lauderdale when the original was damaged. They make them for a number of manufacturers. I have no association with the company other than as a past customer. Use the spelling and add Fort Lauderdale in google. Otherwise, I've designed them from scratch and gone to a large engraving firm in San Diego. I tried trophy shops and the like, but no joy. Finding a high-end engraving company willing to be involved is a lot more difficult than I thought it would be. Most didn't seem to like to wander out of their comfort zone, and there may not be any real cost savings unless you do the design work and electrical interface yourself.

The picture is before I installed the LED's and lightwire.

What boat is the panel on (manufacturer)? Have you tried the manufacturer? Most are made for a manufacturer only and have a small circuit board in them.

He's right that they should be able to replicate it.

Some aren't able to like the Searay panels prior to the square one....maybe pre 2002.

Prospect Plastics, can certainly do the job for you!

Address: 836 NE 44th Street, Ft. Lauderdale, FL 33334

Prospect plastics is very good I know Robert over there very well. Also Rick at Edco does good work also. Both are capable of making a plexi (or other material) panel for you.

I used Prospect Plastics years ago to fabricate a flybridge access door on our Broward. Work was good, but if it's pricey there are other plastic suppliers with engraving capability in adjoining cities/counties. If you can supply a .dwg or illustrator file, most of them have engraving equipment.

Edco can do all of the engraving as well. Their main location is in Hollywood, but they have several satellite locations all over Broward.

Capt Bill11,
You're welcome, and thank you for reporting back. I'm pleased that it worked out.