Click for Mulder Click for Westport Click for YF Listing Service Click for Abeking Click for JetForums

sinking aft cabin

Discussion in 'Technical Discussion' started by terry krause, May 4, 2012.

You need to be registered and signed in to view this content.
  1. terry krause, May 4, 2012
    #1
    terry krause

    terry krause Guest

    tonight we went on a small cruise i noticed the bilge was running more than normal. Checked the engine room and water was squirting from beneath the stbd fuel tank towards the rear of tank just about sunk made it back to harbor to be lifted. Had about an inch of water in the rear stateroom does anyone have any input?
  2. AMG, May 4, 2012
    #2
    AMG

    AMG YF Moderator

    Joined:
    Jul 26, 2004
    Messages:
    5,380
    Location:
    Sweden
    Hi, what boat and year is it you have? Does no water coming out after you lifted it?
  3. Pascal, May 4, 2012
    #3
    Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,546
    Location:
    Miami, FL
    That much water should be easy to trace... Start with shaft stuffing box, rudders, strut bolts and sea cocks. Does the bilge under the aft cabin open to the engine room? If it is not, then the leak was somewhere aft. If it is open, a big flaw, then the leak could be in the ER and just migrated aft

    Just curious, how many and what size bilge pumps do you have? If your pumps couldn't keep up either the leak was massive or you need to upgrade them. Most smaller boats have those tiny bitty things that are completly inadequate.
  4. NYCAP123, May 4, 2012
    #4
    NYCAP123

    NYCAP123 Senior Member

    Joined:
    Mar 14, 2008
    Messages:
    11,208
    Location:
    Long Island, NY
    You had that much water coming in and just ran for shore without looking for the source?:eek: You're very lucky you didn't end up swimming. Pascal gave you some good possible sources, but you'd have probably saved trouble-shooting $ if you had narrowed in down at the time. It may have even been something so simple as a hose coming lose or a lose clamp that you could have fixed without any additional damage. Lesson learned for the future I hope. Good luck.
  5. Kafue, May 4, 2012
    #5
    Kafue

    Kafue Senior Member

    Joined:
    Nov 29, 2006
    Messages:
    1,166
    Location:
    Gold Coast Australia
    Also, check the float switches.
    I usually check mine every few trips and lately found a NEW float switch not working after only two months since it replaced the old mercury switch that came with the boat and was not reliable.
    Maybe they make them in China now!
  6. Pascal, May 4, 2012
    #6
    Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,546
    Location:
    Miami, FL
    Yes it s AMAzing how many boats don't have adequate bilge pumps and how many boaters don't test their pump regularly. I usually do the rounds every month and whenever possible have someone monitoring the warning lights to make sure these works too
  7. Marmot, May 4, 2012
    #7
    Marmot

    Marmot Senior Member

    Joined:
    May 20, 2007
    Messages:
    3,311
    Location:
    9114 S. Central Ave
    It sounds like a person who didn't have the troubleshooting experience or enough familiarity with the boat to quickly locate the source of flooding and correct it (if even possible) made a very good decision and headed for shore (and or assistance) before sinking rather than watch the water rise until those options were no longer available.
  8. NYCAP123, May 5, 2012
    #8
    NYCAP123

    NYCAP123 Senior Member

    Joined:
    Mar 14, 2008
    Messages:
    11,208
    Location:
    Long Island, NY
    Agreed. However.....